针对某电厂锅炉氮氧化物排放量超标的问题，利用前处理软件Gambit建立炉膛模型，设置相应的边界条件，利用Fluent软件对炉内NOx生成进行了数值计算，研究了煤粉浓淡比对脱硝效果和燃烧特性的影响。结果表明：随着煤粉浓淡比的增大，NOx排放浓度逐渐降低，并且趋于平缓，而飞灰含碳量则随着煤粉浓淡比的增大呈线性增大，建议合理的煤粉浓淡比为6。
Abstract
Aiming at the problem of nitrogen oxide emissions exceeding the standard in a power plant,the model of the furnace was built by using the software Gambit,and the corresponding boundary conditions were set up.The NOx generation in the furnace were calculated by using software Fluent.The effect of pulverized coal bias ratio on the denitrification and combustion characteristics was studied.The results show that,with the increase of the pulverized coal bias ratio,NOx emission concentration decreases gradually,and tends to be gentle,but the carbon content of fly ash increases linearly,The authors suggest that the reasonable pulverized coal bias ratio is 6.
关键词
氮氧化物 /
低氮燃烧器 /
煤粉浓淡比 /
飞灰含碳量
{{custom_keyword}} /
Key words
Nitrogen oxide /
Low NOx burner /
Pulverized coal bias ratio /
Carbon content of fly ash
{{custom_keyword}} /
{{custom_sec.title}}
{{custom_sec.title}}
{{custom_sec.content}}
参考文献
[1] 付忠广,石黎,段学农,等.低氮改造对四角切圆锅炉NOx生成特性的影响[J].动力工程学报,2015,35(3):185-190.
[2] 毕明树,张丛,周一卉.煤粉浓淡空气分级燃烧过程的数值模拟[J].动力工程学报,2010,30(8):612-616.
[3] 周秋月,朱全利,方彦军.浓淡偏差直流燃烧器炉内燃烧过程及NOx生成的数值模拟[J].华中电力,2002,15(6):5-7.
[4] Daisuke Shimokuri,Shinichi Fukuba,Satoru Ishizuka.Fundamental investigation on the fuel-NOx emission of the oxy-fuel combustion with a tubular flame burner[J].Proceedings of the Combustion Institute,2015,35(3):3573-3580.
[5] 宋东辉,刘文静,郭婷婷,等.四角切圆燃烧锅炉底层燃烧器区域流场数值模拟[J].东北电力大学学报:自然科学版,2009,29(4):64-66.
[6] 王志刚,禚玉群,陈昌和,等.四角切圆锅炉流场伪扩散效应网格的研究[J].中国电机工程学报,2007,27(5):22-28.
[7] 赵立业,辛国华.600MW四角切圆燃烧锅炉炉内过程的数值模拟[J].东北电力大学学报:自然科学版,2008,28(6):48-52.
[8] 于勇,张俊明,姜连田.FLUENT入门与进阶教程[M].北京:北京理工大学出版社,2008:238-243.
[9] 黄文静,缪正清,王次成,等.300MW四角切圆煤粉锅炉低氮燃烧的数值模拟研究[J].锅炉技术,2014,45(3):39-43.
[10] 潘维,池作和,李戈,等.四角切圆燃烧锅炉燃烧和污染物排放数值模拟[J].浙江大学学报:工学版,2004,38(6):761-764.
{{custom_fnGroup.title_cn}}
脚注
{{custom_fn.content}}
基金
吉林省科技发展计划重点资助项目（20110409）
{{custom_fund}}
PDF(4965 KB)
